- 3 -
-Content (S/W)-
Auto calibration and basic operations
29
Button description
29
RUN mode
30
First Auto calibration
30
Entire modes and functions
31
Auto calibration (AUTO CAL)
31
Auto 1 calibration (AUTO 1)
32
Auto 2 calibration (AUTO 2)
33
Auto 3 calibration (AUTO 3)
33
BIAS calibration (BIAS)
33
Velocity calibration (V_0)
33
Manual mode (MANUAL)
34
Parameter mode (PARAM)
35
Parameter types
35
Parameter adjustment
35
Deadzone (dEAdZONE)
35
P control (KP)
36
I control (KI)
37
D control (KD)
38
Hand calibration mode (HAND CAL)
39
Hand calibration types
39
Adjustment of valve zero and end point
39
Adjustment of transmitter zero and end point
40
Valve mode (VALVE)
42
Adjustment of acting type (ACT)
42
Adjustment of characteristics (CHAR)
43
Adjustment of user characteristics (USER SET)
43
Adjustment of Tight Open mode (TSHUT OP)
44
Adjustment of Tight Close mode (TSHUT CL)
45
Adjustment of split range (SPLIT)
46
View mode (VIEW)
46
Error and warning code
47
Main software map
49
- 4 -
Manual description
Thanks for purchasing our products.
Our products are produced and inspected under the strict standards. In order to use the
products appropriately and efficiently we recommend that users read this manual carefully
and fully understand.
* This manual should be delivered to the end user.
* This manual can be changed without prior notice.
* This manual, in whole or part, shall not be transcribed or copied without approval by
YTC.
* Changes of specification, structure and components may not lead to the immediate
revision of this manual.
Notes on safety and warranty
* Before handling YT-2300, it is absolutely imperative that users read and observe the
safety instructions in this manual in order to ensure the protection and safety of
operators.
* We do not have responsibility for the damage caused by users' repair or conversion of
the item. If the repair or conversion is necessary, submit inquiries.
* Warranty period is marked on the quotation sheet, which is free of charge in principle.
* For the following cases some cost shall be charged.
- Inappropriate maintenance by users
- Inappropriate transportation and storage
- The product is used beyond specification.
- Inappropriate installation
- Uncontrollable disaster such as fire, earthquake, storm, flood, etc
