4-18
Dismantling or installation of bucket
Safety rulers
When you hit the pins with hammer to extract them, splinters may be
produced and hit you, it may cause severe injure and permanent
damage in your eyes. So use protective eyeglasses and heavy
gloves.
When remove the bucket from the working equipment put it in a
stable position.
Be sure that people standing around working zone, keep clearance
from the bucket range when you hit the pins, because if you hit hard,
the pins may fly off to result in the damage.
Don’t put any part of the body or stand underneath the bucket when
removing the bucket.
Be careful not to bumps your hands
Don’t put your hands in the pin which is aim at the o-rings rightly.
Bucket installation
Stop the machine on a firm and
solid ground.
Start the machine then operate
the arm till the hole of the arm
and bucket in a line, then put a
steel bar into it.
Raise the arm and bucket, dozer the blade
Extend the bucket cylinder to align the hole of the arm and bucket. Insert
the pin
②
, then take out the steel bar
①
, insert the pin
③
Dismantling bucket
Stop the machine on a firm and solid ground. Lower the arm until the
bucket touches the loader face softly, or else more is ground contact
pressure more difficult is remove the pins from bucket.
Remove the split-pin from pins, the spacer and then the o-ring anti
clearance. Remove bucket pins and
③
,in this order.
