20
Laden von Lithium-Akkus
1
Der Wert links setzt den Ladestrom fest, der Wert
rechts die Spannung des Akkupacks. Nachdem Sie
Ladestrom und Spannung eingestellt haben, drück-
en Sie
START / ENTER
für mehr als drei Sekunden,
um den Vorgang zu starten.
2
Hier wird die Anzahl der von Ihnen voreingestellten
Zellen
S
sowie der vom Prozessor erkannten Zellen
R
wiedergegeben. Sind beide Werte identisch, dann
können Sie den Vorgang mit
START / ENTER
start-
en. Falls nicht, drücken Sie
BATT TYPE / STOP
, um
zum vorherigen Menüpunkt zurückzukehren und die
Anzahl der Zellen des Akkus nochmals zu prüfen,
bevor Sie voranschreiten.
3
Anzeige der verstrichenen Ladedauer in Echtzeit.
Einmalig
BATT TYPE / STOP
drücken, um den
Ladevorgang abzubrechen.
Charging of Lithium Battery
1
The value on the left side of the second line sets
the charge current. The value on the right side of
the second line sets the battery pack’s voltage. After
setting current and voltage, press
START / ENTER
for more than 3 seconds to start the process.
2
This displays the number of cells you set up and
the processor detects.
R
shows the number of cells
detected by the charger and
S
is the number of cells
set by you at the previous screen. If both numbers
are identical, you can start charging by pressing
START / ENTER
. If not, press
BATT TYPE / STOP
button to go back to previous screen and carefully
check the number of cells of the battery pack before
going ahead.
3
This screen shows the real time Status during
charge process. Press
BATT TYPE / STOP
key
once to stop the charge process.
Individual Cell Connection Diagram (pin-assignment of 8 - pin)
Summary of Contents for Karate Nighthawk AC/DC
