Page 4
For technical questions, please call 1-888-866-5797.
Item 56812
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Note: Finger tighten hardware
until assembly is complete.
1. Assemble on a flat, level, hard and smooth surface
capable of safely supporting a fully loaded Cart.
2. Attach two Fixed Casters (12) to one side
of the Bottom Shelf (11) using eight sets of
Long Bolts (8), Washers (3) and Nuts (4).
Note:
Long Bolts (8) have hex heads. Long Bolts (8)
are slightly longer than other Bolts (2).
3. Attach two Locking Swivel Casters (10) to other side,
using eight sets of Long Bolts, Washers and Nuts.
4. For the left side, attach a Cross Support (9)
between one each Right-handed Post (1)
and Left-handed Post (6), using two sets
of Bolts (2), Washers and Nuts.
Cross
Support (9)
Left-handed
Post (6)
Bolt (2)
Washer (3)
Nut (4)
Right-handed
Post (1)
Front of Cart,
left side
5. Repeat for the right side.
Note:
Assemble Right-handed Post (1) in front
on the right side and Left-handed Post (6) in front
on the left side. See Diagram on page 7.
6. Lock Swivel Casters.
7. Attach Post assemblies to the outside
corners of the Bottom Shelf, using sixteen
sets of Bolts, Washers and Nuts.
Bolt (2)
Washer (3)
Nut (4)
WARNING! TO PREVENT SERIOUS INJURY: The
Chest (5) is heavy. Do not attempt to lift and lower
onto Cross Supports without assistance. Support the
Chest fully until it is completely secured to the Posts.
8. With assistance, lift up the Chest, then lower
it carefully between the Posts until its bottom
edges rest on the Cross Supports.
9. Attach the Handle (7) to lower holes on the
same side as Locking Swivel Casters, using two
sets of Long Bolts (8), Washers and Nuts.
10. Secure Posts to Chest using fourteen
sets of Bolts, Washers and Nuts.
Long
Bolt (8)
Bolt (2)
Handle (7)
Chest (5)
11. Carefully hold the lid open. Install a Lid Support (13)
on each end of the lid using two Nuts (4).
Nut (4)
Lid Support
(13)
Nut (4)
12. Wrench tighten all hardware.
