•
The scope has been reinforced with an IPX6 rating against water intrusion and can be used in
inclement weather; however, it is not intended for full submersion.
•
Attempting to disassemble or repair the scope will void the warranty!
•
Clean the scope's optical surfaces only if necessary, and use caution. First, remove (by blowing
or carefully wiping off) any dust or sand particles. Then proceed to clean by using a soft cotton
tissue and alcohol or a cleaning solution approved for use with multicoated lenses. Do not pour
the solution directly onto the lens!
•
The scope can be used in operating temperatures, ranging from -30°C to +40°C. However, if it
has been brought indoors from cold temperatures, do not turn it on for 3 to 4 hours.
•
If the riflescope is unable to mount onto the rifle securely, or if there are doubts about the
mounting system, see a qualified gunsmith. Using the weapon with a poorly mounted scope can
lead to inaccurate target shooting!
•
To ensure reliable performance, it is recommended to carry out regular technical inspections of
the unit.
BATTERY INSTALLATION
•
Unscrew the cap (1) of the battery compartment counter-clockwise
•
Install one AA (1.5V) or CR 123 (3V) battery, so that the (+) and (-) match the markings on the
body of the unit
•
Tighten the cap (1)
OPERATING THE PHANTOM
•
Install the batteries according to the directions in the section entitled “BATTERY
INSTALLATION”
•
Enter a dark environment
•
Remove the objective lens cap by sliding it up on top of the objective lens (2)
•
Turn on the unit by turning the selector switch (3) to the “ON” position; you will see the
screen of the electronic-optical converter light up green
•
The scope can also be checked in an illuminated area, but this is meant solely for testing the
device; the lens cap (2) must tightly cover the objective lens
•
To adjust the brightness of the red reticle, turn knob (4)
•
To select one of the five (three - if EPM66G tube employed) types of red reticles, press button
(5)
•
Choose a removed stationary object to observe, at a distance of about 100 m
•
Turn the focusing knob (6) to “100”, it will settle into a notch
