Revised 03-11-10
YUNCA FUZiON FEBRUARY 2010
Page 3 of 19
INTRODUCTION
Welcome and congratulations on purchasing your YUNCA FUZiON (Fuzzy Logic Control)
FLUED GAS HEATER.
Please read the following carefully before attempting to operate the heater and ensure all members
of your home understand how this elegant and highly efficient heater functions.
Please fill out and return the registration card promptly (back page)
These instructions should be stored in a convenient safe place for ready reference. If you have any
questions regarding your heater please contact your YUNCA dealer.
The YUNCA
FUZiON
(Fuzzy Logic Control) FLUED GAS HEATER is a gas-fired, conventionally
vented, room heater tested by independent laboratories to Australian and New Zealand standards.
Electronic ignition and operation is by an infra-red remote control handpiece (Ref page 8 – 10).
However if your remote is mislaid or damaged there is a convenient manual control panel (page 11)
on the front of the fire. Both the remote and the control panel feature “kiddy-lock” controls for added
peace of mind. We highly recommend the use of the two-speed fan boost on the fire for greater
heating efficiency.
Should power not be available for any reason, battery back up through two “D” sized batteries
ensures the fire will continue to operate (without the fan boost). Ref page 12.
The installation of the YUNCA
FUZiON
(Fuzzy Logic control) FLUED GAS HEATER must be carried
out by a suitably qualified person and comply with the current New Zealand installation code, NZS
5261:2003.
WARNING
:
This appliance must be flued to atmosphere
.
Installation and repair of the YUNCA
FUZiON
FLUED GAS HEATER must be carried out by a
qualified person.
The appliance should be serviced at least annually by a qualified service person.
Control valve
compartments, burners, fan, and air circulating passageways of the FUZiON must be kept free from
any lint and dust build-up to ensure efficient and safe operation of the heater.
CAUTION: DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
This particularly applies to the remote control handpiece!
WARNING: DO NOT USE OR STORE FLAMMABLE MATERIALS
NEAR THIS APPLIANCE.
WARNING:
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS
APPLIANCE WHILE IT IS OPERATIONAL.