8
ANNUAL AIRCRAFT
MAINTENANCE
(Authorized Service)
ATTENTION: The following work must be carried out by a specialist workshop
or an authorized branch of Yuneec!
Aircraft
The following work/inspection will be done by your specialist workshop
Inspection in the H520
remove any dirt and dust particles.
Inspect the motherboard for cracks or fractures.
Remove dust and dirt particles from the GPS module.
Inspect all solder joints
Replace the battery connector
Secure all metal parts with threadlockers
Inspect camera
Open camera and remove dust and dirt particles.
Clean the lens board.
Clean the antennas.
Inspect the antenna connection
Check the attachment points and connections
Check the sensors for function
perform manual calibration
ST16S ground station
Check the fan bearings
Clean the joystick connection points with contact spray.
Clean potentiometer of gimbal controls with contact spray
Clean potentiometer of gas controls with contact spray.
Removal of dust and dirt particles from the electronic components.
Perform the inspection flight. Log the inspection/maintenance.
