Owner's Manual
TX158 ATV Trailer
Check for parts online at
www.yutrax.com
or call 800-345-6007 M-F 8-5 CST
Page 4
8. Slide the two wheels (13) onto the axle spindles (6) with
grease fittings and air valves facing outward. Secure with
two 20mm castle nuts (17) and 20mm steel washers (14).
Tighten the castle nut until snug and then back off slightly
to allow free movement of the wheels and cotter pin (27)
alignment. SEE FIGURE 5
9. Insert the two cotter pins (27) through the axle spindles
(6) and castle nuts (17) so that the head of each cotter pin
is seated in the corresponding castle nut. Using a pair of
pliers, bend the prongs of the two cotter pins around the
other side of the castle nuts so that the cotter pin cannot
fall out. SEE FIGURE 5
10. You must now tighten all nut and bolt assemblies.
Be sure not to over tighten or crush tubing when
tightening.
11. Grease both wheels with a grease gun and high quality
bearing grease. Check the grease level frequently to
prevent bearings from excessive wear or failure.
12. Slide the removable tailgate (3) into the channels on
the rear trailer frame (2). Slide the four side containment
racks (8) and the one front containment rack (9) into the
corresponding tubes on the trailer frame assembly.
SEE FIGURE 5
NOTE: Make sure the tire pressure does not exceed the
maximum rating written on the tire. Recommended
operating pressure is 7 psi.
OPTIONAL ACCESSORIES
TX113 2" Ball Hitch Kit
TX191 Tracking Beam Kit
FIGURE 5
13
6
17
14
27
3
2
8
9
