6. Directions For Use
Adjustment of pedal height: loosen the
set screws on the fastener with a
hexagon wrench, adjust the pedal to the
appropriate height according to the
height of the occupant and lock the set
bolts, see Figure 9.
Installation and removal of anti-roll
wheel: hold the marble on the anti-roll
wheel with your fingers while installing
and insert it into the frame hole until the
marble fastens into the marble hole of
the wheelchair. While removing, hold the
marble with one hand and pull the
anti-roll wheel off backwards with the
other hand, see Figure 10 (Note: tighten
the cap nut on the inside while installing).
Note
To avoid pinching, do not put your
fingers into the folded backrest .
Figure 9
Figure 11
Figure 12
Figure 14
Figure 15
Figure 10
Use of movable leg: when the electric wheelchair is provided with a
movable leg, turn the movable leg from the position in Figure 11 to the
position in Figure 12 along the rotational axis, ensuring that it rotates
into the groove of the plastic part and open the pedal; the action
sequence is reversed to folding back up. (Note: the function is only
suitable for models provided with a movable leg)
Adjustment of controller: sit on the
electric wheelchair, loosen the torx
bolt, push the fixing rod of the
controller backwards and forwards
to the proper position and lock the
torx bolt, see Figure 13. (The
adjustment method is same if the
controller is installed on the left
side)
Figure 8
Figure 13
(1). Function description of controller
Power button
Battery gauge
Horn button
Speed indicator
Acceleration
button
Deceleration
button
08
09
Charger/
programming port
UDB interface
Joystick control panel
Joystick
