YWH100 IP Phone User manual V1.38
Page 19 of 32
(2)protocol settings
Fig 9 Protocol Setting Page
●
protocol:
Select an item from dropdown list to set the protocol used by the phone.
h323: Select this item to set the phone use H323 protocol.
sip: Select this item to set the phone use SIP protocol.
mgcp: Select this item to set the phone use MGCP protocol.
n2p: Select this item to set the phone use Net2phone private system.
iax2:
Select this item to set the phone use IAX2 private system.
wp:
Select this item to set the phone use WP private system
Note
With Net2phone selected here, please set other necessary parameters: check
use service option, and then fill IP address or domain name of designated
server into service addr field; then set service port as 6801; fill account and
password of Net2phone card into account and pin fields.
●
use service:
Enable/disable service by checking/unchecking this box. Different service
responses different protocol as follows:
With H323 protocol used, the protocol service refers to the gatekeeper searching
the address. To let IP phone call each other by E.164 number, please check this
box and then fill the IP address or domain name of corresponding gatekeeper
into service addr field. Without this check box being selected, the phone can call
by gateway or just by dialing IP address of other IP phone or H323 device (such
as Netmeeting) at the same network segment.
With MGCP protocol used, the protocol service refers to Call Agent. Please
check this box according to system, and then fill service addr field with Call
