GSM/CDMA/WCDMA/4G(LTE) MOIP Gateway
YX Technical department
~ 10 ~
3.2 Equipment IP Address
The default IP of MOIP Gateway WAN port is 192.168.1.10, while the default LAN port IP is
10.10.10.1(The Version not up the LAN port).
3.3 Equipment Connection
Follow the steps below to install the MOIP Gateway to Network.
1) Fix the antenna to the MOIP Gateway. (Optional)
2) Insert SIM card(s) to slots.
3) Connect an Ethernet Cable to the WAN port of MOIP Gateway. The other end of the
Ethernet Cable should be connected to Network port of route or switch.
4) Connect an Ethernet Cable to the Network port of MOIP Gateway. The other end of the
Ethernet Cable should be connected to PC or other network device. (Optional)
5) Plug in the MOIP Gateway.
3.4 LED Indicators
There are a set of LED lights in the front of MOIP Gateway. Lights will be on or glittering when the
MOIP Gateway is power on and running. The following table describes various meanings of status
corresponding to LED lights in different display color.
Power
It indicates whether the system is running or not.
Calling
That one Card slot light to keep bright
Lock card
That one Card slot light flashing(0.5s/times)
No balance / SMS Control
(Meet these conditions
when the lock card)
That one Card slot light flashing(2s/times)
The device did not start
successfully
All slot lights keep bright
4 Web Settings
This chapter describes how to set up MOIP Gateway through Web Page. There is a built-in web
server which can be accessed at URL: http://GATEWAY_IP/, while GATEWAY_IP is the WAN IP
address of the MOIP Gateway, such as 192.168.1.10.
As an example, the following introduction will base on the MOIP Gateway with WAN IP
192.168.1.10.
