GSM/CDMA/WCDMA/4G(LTE) MOIP Gateway
YX Technical department
~ 27 ~
Fields are specified as following:
Billing: Specify whether enable MOIP billing or not. If set to Enabled, system will bill the
outbound calls for the port which has been assigned with billing tariffs.
Hangup The Call: Specify whether enable hangup the call when balance is ont enough.
When select enable, the call will be hang up immediately when run out of balance. But when
you select disable the call will not be hangup.
USSD Check: Specify whether enable to get balance through USSD check or not. This field
takes effect only when MOIP Billing is set to Enabled.
Auto Query Balance
: Query USSD at fixed time intervals.
The screenshot below shows the operation mode to set Caution Balances, Invalid Balances and
The provider ID is detected by MOIP Gateway automatically. For a new Gateway without any card
inserted, there may be no records in the two lists.
Provider ID: Carrier code, different operators can be set separately
Query Method: USSD/SMS, If you set USSD, please set USSD Query Keyword List , If you set
SMS, please set SMS Query Keyword List.
Caution Balances: The device calculates the balance automatically by billing, and when the
forewarning balance is reached, the balance will be queried once to calibrate the balance(Usually
set the balance of 1 minute)
Invalid Balances: Balance after calibration, the implementation of automatic calculation of the
balance again, when less than the invalid value will lock, and prompts you(Usually set the balance
of 1 minute)
