YZ Systems Milton Roy • 201 Ivyland Road • Ivyland, Pennsylvania • USA • 18974 • P: 281.362.6500 • www.yzsystems.com
Page 44
NJEX EUR ver. 08-2021
Section 7: Calibrating Signal Inputs
Pulse Flow Input Calibration,
Dry Contact & Voltage Pulse
Choose
*Set
from the main menu,
figure 105
.
Choose
*Cal
from the set select menu,
figure 106
.
Choose
*Inputs
from the calibration set menu,
figure 107
.
Choose
*Flow
from the flow input type menu,
figure 108
.
Choose
*Pulse
from the flow input type menu for
digital pulse inputs, i.e. dry contact, voltage pulse, etc,
figure 109
.
Calculate Pulse Input Frequency
the example contained in Figure 113 on page
a technician can calculate the Pulse Input Fre-
quency required to effectively calibrate the NJEX
System.
If the pulse input frequency is between 1-1000 pulses
per second (Hz), choose PPS,
figure 110
.
-OR-
If the pulse input frequency is between 1-100 pulses
per minute, choose PPM,
figure 110
.
Span Adjustment
, is used to calibrate the N-300G
controller for 100% of metered flow at maximum input
frequency, i.e. 100 pulses per second at maximum
gas flow.
To set the span adjustment
,
figure 111
& 112,
press
and release the
Select
key. The value entry will
begin to flash when it is chosen. Use the
Up Arrow
key to increase the value and the
Down Arrow
key
to decrease the value. When a new value has been
chosen press the
Enter
key to store the value into
memory. The value entry will stop flashing when
loaded into the memory.
Figure 105
pmp bat vmtr sig tnk
PropFlow
Idle
*Strt *Dsp *Set
pmp bat vmtr sig tnk
Set Selection
*Par *Cal *Esc
pmp bat vmtr sig tnk
Calibration Set
*Clk *Inputs *Esc
pmp bat vmtr sig tnk
Calibration
*Flow *Pres *Esc
pmp bat vmtr sig tnk
Flow Input Type
*Ang *Pulse *Esc
Figure 106
Figure 107
Figure 108
Figure 109
pmp bat vmtr sig tnk
Span Adjustment
50 Pul/sec *Esc
pmp bat vmtr sig tnk
Span Adjustment
30 Pul/min *Esc
Figure 111
pmp bat vmtr sig tnk
Pulse Input Scan
*PPS *PPM *Esc
Figure 110
Figure 112
Summary of Contents for NJEX 6300G
