Chapter 2 Basic Installation 10
Chapter 2 Basic Installation
System Requirements
Before installing and using your VUS-100, make sure your system meets the following requirements:
One set of access point compliant with IEEE 802.11b/g/n
One set of PC installed with 10/100 Base-TX network adapter
Keep the IP address of PC, access point and VUS-100 in the same network segment. By default,
VUS-100 is set to 192.168.1.1, configure the IP address of PC to 192.168.1.X (X can not be 0, 1
or 255)
A Web browser on PC for configuration such as Microsoft Internet Explorer 6.0 or above
Package Contents
The package you have received should contain the following items, if any of them are not included or
damaged, please contact your local vendor for support:
VUS-100 Virtual USB Storage × 1
5V Power Adapter × 1
USB Converter × 1
Product CD × 1
Hardware Installation
Please follow the steps below to install your VUS-100:
Power on VUS-100, and connect it to your computer with an USB converter after the
WLAN(green) lights up;
Wait for the VUS-100 driver auto installation. Insert the attached product CD and copy the
Utility.exe in it to your PC. Double-click to open this utility and make configuration for your
Summary of Contents for VUS-100
