Chapter 3 Basic Settings 12
Chapter 3 Basic Settings
Factory Default Settings
The VUS-100 is set to default values when you first use it. The following table demonstrates the
default settings of VUS-100, you can re-acquire these parameters by resetting the device. If
necessary, please refer to
Restore Factory Default Settings
Table 2 VUS-100 Factory Default Settings
Item
Default Value
Device Name
VUS-100
UPnP Disable
IP Address
192.168.1.1
Gateway IP
192.168.1.254
Subnet mask
255.255.255.0
Primary DNS
0.0.0.0
Second DNS
0.0.0.0
SSID any
Encryption Disabled
Output Power
Full
Security Auth-type
Open System
Note:
Please reboot your VUS-100 after modifying its configuration, refer to
for
how to reboot your device.
Utility & Web - Double Management Tools
VUS-100 provides you with two ways for management:
Utility
and
Web
. You can use either of them
to check and configure your USB storage settings.
Follow the steps below to start them:
Utility Management Tool
Summary of Contents for VUS-100
