6
Value Description
0
No (Default)
1
To same node as wake up notification
2
Broadcast to neighbors
Batteries
The unit is operated by batteries. Use only
batteries of correct type. Never mix old and
new batteries in the same device. Used
batteries contain hazardous substances and
should not be disposed of with household
waste!
Technical Data
IP Rating
IP 20
Battery Type
1 * CR2032
Frequency
EU: 868.4 MHz (EN 300 220) or
RU: 869.0 MHz (GKRCh/EN 300 200) or
US: 908.4 MHz (FCC CFR47 P 15.249)
Wireless Range
Up to 100 m outside, on average up to 20 m
inside buildings
Explorer Frame
Support
Yes
SDK
4.54 pl1
Device Type
Slave with routing capabilities
Specific Device Class Multilevel Remote Switch
Routing
No
FLiRS
No
Firmware Version
1.3
Dimensions
50 x 30 x 10 mm
Weight
30 gr.
Z-Wave.Me guarantees that every device is free from
physical defects in material and workmanship under
normal use for one year from the date of purchase. If
the product proves defective during this one-year
warranty period, Z-Wave.Me will replace it free of
charge. Z-Wave.Me does not issue any refunds. This
warranty is extended to the original end user
purchase only and is not transferable. This warranty
does not apply to: (1) damage to units caused by
accident, dropping or abuse in handling, or any
negligent use; (2) units which have been subject to
unauthorized repair, taken apart, or otherwise
modified; (3) units not used in accordance with
instruction; (4) damages exceeding the cost of the
product; (5) transit damage, initial installation costs,
removal cost, or reinstallation cost. For information on
additional devices, please visit us online.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential
installation.
This
equipment
generates, uses and can radiate radio frequency
energy and if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the
equipment and receiver. (3) Connect the
equipment into an outlet on a circuit different
from that to which the receiver is connected. (4)
Consult the dealer or an experienced radio/TV
technician for help. Any changes or modification
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the device.
Where shielded interface cables have been
provided with the product or specified additional
components or accessories elsewhere defined to
be used with the installation of the product, they
must be used in order to ensure compliance with
FCC regulations.
CE for Class B ITE (Following European standard
EN55022/1998; EN61000- 3-2/1995; EN61000-
3-3/1995, EN55024/1998, EN60950-1/2001)
