This product is a secure electronic door lock that supports the Z-Wave Plus
TM
standard, which is
compatible with earlier versions of Z-Wave
TM
.
This product can be included and operated in any Z-Wave network with other Z-Wave certified
devices from other manufacturers and/or other applications. All mains operated nodes within the
network will act as repeaters regardless of vendor to increase reliability of the network.
The device can be included in the Z-Wave network using S0 or S2 Access Control security.
Inclusion can be via standard inclusion, SmartStart:
Z-Wave Specifications
●
Device Type : Door Lock (SPECIFIC_TYPE_ DOOR_LOCK)
●
Role Type : LSS (Listening Sleeping Slave)
●
Command Cass Support/Control
Standard Network Inclusion / Exclusion
Please proceed with the door lock open.
●
To add or include this product into a Z-Wave network
1. Set the controller in inclusion mode.
2. Open the battery cover of the indoor body and press the [REG] button.
3. Press the Master Pin [1][2][3][4] (Default value) button after pressing the [#] button.
4. Press the [8][8] button after pressing the [#] button.
5. If the controller supports S2 security, you will be prompted to enter the first 5 digits of the
DSK to complete the authentication, known as the Pin Code.(You can check the DSK and
QR code by removing the battery cover of the product or package box)
●
To remove or exclude the GKBC-3100Z into a Z-Wave network
1. Set the controller in exclusion mode.
2. Open the battery cover of the indoor body and press the [REG] button.
3. Press the Master Pin [1][2][3][4] (Default value) button after pressing the [#] button.
4. Press the [9][9] button after pressing the [#] button.
SmartStart
SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR
Code present on the product with a controller providing SmartStart inclusion. No further action is
required and the StartStart product will be added automatically within 10 minutes of being switched
on in the network vicinity.
(You can check the DSK and QR code by removing the battery cover of the product or package
box)
