6
Cannot carry out
inclusion and association
1. Run out of battery
power
2. Check if reverse
battery polarity
3. Check if the detector
is out of order
1. Replace a new
battery
2. Refit the battery
with correct polarity
3. Ensure the
detector is
working properly
Cannot control the
connected modules
1. Run out of battery
power
2. Check if the detector
is out of order
1. Replace a new
battery
2. Ensure the
detector is working
properly
The detector not working
1. Run out of battery
power
2. Check if the mounting
location is proper
3. Check if the detector
is out of order
1. Replace a new
battery
2. Reposition its
mounting location
3. Do not open
HSD-200Z, send it
to the local retailer
to be fixed.
Specifications
Battery
1.5V AA type size x 3
Range
Up to 100 meters line of sight
Warm Up Time
About 5 minute
PIR Detection Coverage
Wall-Mounted:
Ceiling-Mounted
Up to 10m x 110
°
(at the height of 1.8 m & Op. temp. 25
°
C)
Up to 5m x 360
°
(at the height of 2 m & Op. temp. 25
°
C)
Frequency Range
908.42 MHz (US) / 868.42 MHz (EU)
*Specifications are subject to change without notice
A501110874R02
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
WARNING:
Do not dispose of electrical appliances as unsorted municipal waste, use separate
collection facilities.
Contact your local government for information regarding the collection systems
available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances
can leak into the groundwater and get into the food chain, damaging your health
and well-being.
When replacing old appliances with new once, the retailer is legally obligated to take
back your old appliance for disposal at least for free of charge.
