20
Transferring Only Network Information to A New
Primary Controller (Primary Shift)
You can just transfer network information to another remote so that it
will become the new primary remote. This is done by following the
steps below.
Step
Setup Key
Setup LED Behavior
1
Press & hold
for 3 seconds
OK LED on
2
Place the two controller
close to each other
3
Type “8362” on the
setup number keypad
OK LED blinks once for
each number input
OK LED keeps blinking
after entering the 4-digit
4
Please make sure the
target controller is setup
to receive information.
(Refer to the target
controller user manual
for more information)
OK LED blinks once then
turns off
Replication completed
