21
Replicating All Network and Device Information from A
Primary Controller to Your HSK-100Z (aka “Learning
Mode”)
Your HSK-100Z can:
Copy the settings from another Z-Wave controller
Be included into existing Z-Wave network and become a new
primary or secondary remote
Be excluded from the Z-Wave network
by following the steps below.
Step
Setup Key
Setup LED Behavior
1
Press & hold
for 3 seconds
OK LED on
2
Place the two controller
close to each other
3
Type “8363” on the
setup number keypad
OK LED blinks once for
each number input
4
Please make sure the
primary controller is
setup to send
information. (Refer to
the primary controller
user manual for more
information)
OK LED blinking then
turns off
Replication completed
Note: If the replication is unsuccessful, the OK light turns off and the
error light will flash 6 times then turn off.
