9
Mounting:
1.
Open the ZTS-100 by pushing the hook (Figure 5)
2.
Install AAx4pcs batteries if using battery power (Alkaline batteries are recommended)
3.
Check the polarity of the batteries and the "+/-" marks inside the battery compartment
4.
Connect 24Vac power if using 24Vac power source
5.
Place the cables at the hole near the terminal block
6.
Insert 2 pieces of wall anchors into the holes of the wall
7.
Fasten the thermostat with 2 pieces of long screws through the 2 mounting holes (Figure 6)
8.
Install the top housing by hooking the bottom (Figure 6)
Figure 5. Open ZTS-100
Figure 6. Install the top housing
