DOC-USR-00XX-0X
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
55
Stereo
Source
Follow video
HDMI1
Analog
HD-SDI
HD-SDI 1+2
HD-SDI 3+4
None
Where to get audio for that subchannel.
“Follow video” causes audio to be assigned
based on the video source selected.
Pid
0 – 8191 (
120,121,122,123
)
If UDP format is selected, the PID to use for
that audio channel.
RTP Port
0 – 9999
(8892 – 8898)
If RTP format is selected, the port #
associated with that audio channel.
Max PTS-PCR
0 – 3000 (
250
)
Allows user to specify a smaller interval than
250ms between PTS and PCR. This is for
systems that require tighter PTS-PCR
intervals. It is generally recommended to
leave this value at 250. Certain decoders
may require a value of Max PTS-PCR similar
to the video delay. If an issue is encountered
with a specific decoder, please try setting
this value to the same value as video delay.
Format
ADTS
LATM
Allows setting of AAC ADTS or AAC LATM.
Most applications use ADTS but some, for
example, ISDB-T, require LATM.
Jumbo PES
None
1-4 AUs
Used for ISDB-T encoding. Should otherwise
be left as “None”.
Output Format
RTP
UDP
TSRTP
RTMP
TSFILE
FILE
MPTS
ASI
Output format of encoded stream.
RTP requires an SDP file for the receiver or
the use of the RTSP URL (see Section 6.5,
“Streaming RTP” on page 17 for more
details).
If UDP is selected, don’t forget to check the
value of TS Rate to make sure it is in line
with expectation (see Section 6.7,
“Adjusting the UDP TS Rate”, on page 21).
