DOC-USR-0027-10
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
28
6.11
Encoding from Component or Composite In
The Z3-MVPR-02 also supports encode via 1 of 2 component inputs or 1 of 2 composite inputs. These
can be used in addition to the 2x HDMI inputs.
HDMI1, Component1, and Composite1 are all accessible from the “CH1” tab. HDMI2, Component2, and
Composite2 are all accessible from the “CH2” tab.
Most combinations are allowed. However, because of the way the hardware is configured within the
Z3-MVPR-02, two combinations are not allowed. For both of those combinations, an alternative is
available.
below shows the combinations that are allowed and not allowed on the Z3-MVPR-
02.
CH1
CH2
Allowed?
Notes
HDMI1
HDMI2
Yes
Component1
Component2
Yes
Composite1
Composite2
Yes
HDMI1
Component2
Yes
HDMI1
Composite2
No
Use Comp HDMI2 instead
Component1
HDMI2
Yes
Component1
Composite2
No
Use Comp Component2 instead
Composite1
HDMI2
Yes
Composite1
Component2
Yes
Figure 31 Allowed Input Combinations on the Z3-MVPR-02
For Component inputs, Component1 is on the right side looking at the rear panel while Component2 is
on the left (see
). If a standard A/V cable is being used, the following mapping is used: red ->
red, white -> blue, yellow -> green (as shown in
For Composite inputs, the same input jack as Component1 is used. The yellow connector is used for
Figure 32 Mapping of A/V Cable to Component Jacks
