10
CONFIDENTIAL
DOC-USR-0239-04
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
2.0
QUICK START GUIDE
2.1
Before Attaching A Camera Block
Before connecting a camera block, a thorough review of section 7.0 is required.
2.2
If You Have Received a System from Z3 with the Software Preloaded
To start working with the encoder, you can go straight to Section 13
.0 “RUNNING THE ENCODER”
on page
21. This section describes how to quickly stream UDP, RTP, RTSP or RTMP as well as record to a Micro-
SD card. Enabling Pro-MPEG Forward Error Correction
(FEC), Zixi Feeder™ or KLV data are also described.
2.3
If You Already Have a System from Z3 and Need to Update the Firmware
There are several options for updating the firmware on your RPS by following the instructions in Section
15.0:
RUNNING THE CODE YOU BUILT ON THE BOARD
on page 48.
2.4
If You are Ready to Start Development
Details on how to untar and build the code can be found in Section 10.0: UNTARRING AND BUILDING
THE SAMPLE CODE
, on page 15. A brief overview of the code itself can be found in Section 11.0
,” on page
17.
Details on how to set up your system to access the code you have built can be found in Section 15.0:
RUNNING THE CODE YOU BUILT ON THE BOARD
”,
on page 48.
Please Note:
Actual version numbers for your Z3 product may differ from those pictured in this document.
