TROUBLESHOOTING
REF
PROBLEM
SOLUTION
1
THERE IS NO
DISPLAY ON THE
CONTROL PAD.
Check the power outlet and the switch at the
back of the treadmill are turned ON.
Check the Control Pad sensor wires are
connected to the frame (A) and (B) – refer to
the Assembly instructions above.
Place the Safety Key magnet on the yellow
circle on the Control Pad and attach the safety
cord to your clothing.
Press the START key on the Control Pad –
the running belt should move after 3 seconds.
outlet.
Note, the Control Pad will automatically turn
Failing this, call Customer Care.
2
THE CONTROL PAD
IS ON AND THE
MOTOR IS NOT
FUNCTIONING.
Check the voltage – it could be too low.
Check the
Safety Key
is attached to the
Control Pad.
If there is no change, call Customer Care.
3
THE RUNNING BELT
IS LOOSE.
Refer to the
Running Belt Maintenance
section above.
If there is no change, call Customer Care.
4
THE RUNNING BELT
HAS MOVED TO THE
RIGHT OR LEFT.
Refer to the
Running Belt Maintenance
section above.
If there is no change, call Customer Care.
5
THE ANTI-STATIC
AGENT HAS WORN
OFF
Lubricate the treadmill after
approximately 80 hours of use or try the
test of rubbing your hand between the
board and the belt to see if it is dry.
Refer to the
Running Belt Maintenance
section above.
If there is no change, call Customer Care.
