11
to the room during the leaving time, Mini Alarm starts to beep permanently and a new arming starts in the
moment when sensor doesn´t register any movement. You can set up the length of leaving time by a text
message (see page 8). You can cancel arming during leaving time by short pressing of the button.
Problems by arming (motion detector test) can be caused by:
Mini Alarm is not registered to GSM network (1 long beep – deep tone),
there is no telephone number defined in Mini Alarm´s address book (2 long beeps – deep tone).
How to arm:
by short pressing of button or
by sending a text message on telephone number of Mini Alarm (if you are not in the protected
room).
Arming text message has to be of this form: password ARM=ON (e.g.
abcd_ARM=ON
). If you want Mini
Alarm to confirm you the arming on your mobile phone, add a question mark at the end of the message,
e.g.:
abcd_ARM=ON ?
. Arming through text message is performed in silence, immediately after receiving
the message. It means that Mini Alarm doesn´t signal arming acusticly, only green LED light goes off.
How to disarm:
by calling on telephone number of Mini Alarm (before entering the protected room) – after Mini
Alarm refuses the call automatically you can enter the room or
by sending a text message on telephone number of Mini Alarm in this form: password ARM=OFF
(e.g.
abcd_ARM=OFF
).
WARNING! Before leaving the protected room, close all windows and doors to avoid false alarms. False
alarm can be caused also by starting air condition, heating or by movement of animals in the room.
Intrusion into the protected room
If an unauthorized person enters the protected room, Mini Alarm sends a text message and calls on all
telephone numbers defined in the address book. (If you pick up this call, you can hear what is going on in
the room.) Device doesn´t signal anything by LED lights or buzzer to avoid paying attention of the intruder.
After informing about the alarm, Mini Alarm keeps armed status and sends the next alarm text message
after 15 minutes (to avoid sending alarm messages about the same intrusion very often).
Authorized person (e.g. flat owner) turns the device to disarmed status by calling on telephone number of
Mini Alarm or by sending a text message before entering the protected room. Mini Alarm gets disarmed
only if it receives a call from one of the numbers defined in Mini Alarm´s address book (Mini Alarm´s SIM
card has to have CLIP service active). Unknown calls are refused.
B. Tapping of protected room
1. in disarmed status
If you call on telephone number of Mini Alarm, you can hear what is going on in the protected room.
Tapping time is unlimited. The permission for tapping has only the person with telephone number defined
in the address book of Mini Alarm.
2. by an event
You can tap also when Mini Alarm calls you in case of alarm or emergency call (PANIC mode) by picking
up the call from Mini Alarm. Tapping by alarm is automatically ended after 5 minutes, but you can change
this parametre by sending a configuration text message (see page 8). If you want to end
