4
IV. PREPARATION FOR USE
Device description
How to start
1. Check if there is PIN code protection disabled on the SIM card that you want to insert into Mini Alarm.
You can check it by inserting the card to a usual mobile phone. If your mobile phone starts without asking
a PIN code, PIN code protection is disabled. If you had to insert a PIN code, disable this function in your
mobile phone (Settings) as well as the voice mail service.
2. Check if there is CLIP service active on the SIM card. You can check it by calling on the SIM card – if
your phone shows you who is calling, CLIP service is active, if it doesn´t, contact your mobile operator for
activation of the service. Also check if it is possible to send text messages from the SIM card. If not,
please contact your mobile operator.
3. Turn the device upside down. Then gently turn the buttom cover to the left (against the arrows
direction) and take it out. Before inserting the SIM card, jumper can´t be put on (see the pictures below)
and power adapter can´t be connected. If these conditions are fulfilled, open the SIM card holder and
insert the SIM card (watch the inclined corner), close the holder. Put the jumper on.
motion detector
microphone
red LED light
green LED light
power adapter
connector
external sensor
input
speaker
output
jumper
put on
jumper
put off
