6
WARNING!!!
In case you won´t use the device for a long time, put the jumper off. The battery is getting discharged also
when not used, therefore it´s necessary to charge it again before next usage.
GSM network accessibility
GSM network has to be accessible in order to make Mini Alarm work correctly. Signalling of GSM network
accessibility is indicated in table on page 12. If GSM network is not accessible, the reasons could be the
following:
there is no SIM card in the device,
SIM card´s PIN code is not disabled (you can disable it on an usual mobile phone) or it´s
necessary to unblock the card with PUK code,
low signal,
GSM network not accessible because of some problem of the operator.
By installing the device, check the signal power near the device by using a mobile phone (display
indication). If signal power is low, manufacturer recommends to replace device on a place with better
signal.
During electric power failure (and when the battery is fully discharged) or during GSM network failure
DRAGON becomes functionless. After electric power recovery (and charging the battery) and after GSM
network recovery device keeps the same mode as before failure.
Setting up telephone numbers
Mini Alarm needs to know where to send the messages and alarm/emergency calls, therefore it´s
necessary to set up the telephone numbers on the SIM card of Mini Alarm. You can set up the numbers in
the following way:
1. Press the button twice (red and green LED lights start to flash alternately and device beeps once per
second).
2. Then call on telephone number of Mini Alarm from the telephone number which you want to add to
address book of device (it means on which tel. number you want the device to send the messages and
calls). CLIR service has to be disabled on the SIM card from which you are calling. Device ends the call
automatically and if the number was added successfully or already exists in the address book, you will
hear a double beep.
3. If you failed to add the number to the address book, you will hear a long deep tone. Reasons for failed
addition of telephone number to Mini Alarm´s address book can be the following:
there isn´t CLIP service active on Mini Alarm´s SIM card,
there is CLIR service active on the SIM card from which you call,
Mini Alarm´s address book is already full.
For adding another telephone number, you have to run this mode again (by pressing the button twice).
You can cancell this mode by pressing the button once or it will cancell automatically after 2 minutes.
You can add telephone numbers also by sending a text meesage (see page 8). By alarm or emergency
call Mini Alarm calls in the order as the numbers are set up in the address book, it means T1 first, then T2
etc. If you want to check if you set up the numbers correctly, send a text message in form: password, gap
and question mark (e.g.
abcd ?
) on Mini Alarm´s tel. number and you will receive an answer:
abcd T1=09xxxxxxxx T2=09xxxxxxxx T3=# T4=# O=15 L=5 P=OFF PWR=ON ARM OFF
