7
There were 2 numbers set up in this example (T1and T2), # means that this position is not accupied. (For
more information about O, L, P see page 8.)
If you don´t want to change basic settings which are defined in the device from factory (see page 7), Mini
Alarm is now ready for use. If you want to use device as an alarm, please continue on page 10 and if you
want to use it as a tapping device or PANIC button, please continue on page 11 or 12.
Basic settings
Basic settings are settings from factory. After first start of device, values are set in this way:
A Non - changeable parametres
length of call
= 20 seconds
- how long Mini Alarm calls by alarm or emegency call on one telephone number till the call is picked up
number of calls
= 3 trials for each telephone number
- how many times Mini Alarm calls by alarm or emergency call on one telephone number till the call is
picked up
tapping time in disarmed status
= unlimited
B Changeable parametres
password
= abcd
- serves for control of device via text messages, it can contain letters and numbers, manufacturer
recommends to change the password and to write it down (you can´t control Mini Alarm without a correct
password)
leaving time
= 30 seconds
- time during which the arming person has to leave the room
tapping time by alarm or emergency call
= 5 minutes
text of information messages
- messages that inform about following events:
Name
Event
Predefined text of text messages
S0
Name of device
Mini Alarm DRAGON
S1
Alarm
ALARM
S2
Panic
PANIC
S3
Low battery
BATTERY LOW
S4
Electric energy failure
POWER OFF
S5
Electric energy recovery
POWER ON
Mini Alarm sends text messages about alarm, emergency, low battery, electric energy failure and electric
energy recovery. All messages except PANIC are sent only in armed status (ARM ON). PANIC message
is sent in PANIC mode. Information text message is sent on your mobile phone always as S0 + S1 or S0 +
S2 and etc., e.g.
Mini Alarm DRAGON ALARM
alebo
Mini Alarm DRAGON BATTERY LOW
. Text
message about electric energy failure is sent after one hour, about its recovery immidiately. You can
change the changeable parameters by sending a text message (see page 8).
Return to basic settings
If you want to get the basic settings, disconnect the adapter from Mini Alarm (in switched on status), hold
the button till you hear a double beep and connect the adapter to Mini Alarm (to the left
