ZALMAN RESERATOR2, Installation And Operational Manual

9

English

RESERATOR 2

※

The specifications of any product may change without prior notice to improve performance.

5. Installation Guide

5. 1 Determine the Placement of the 

Reserator

The Reserator’s placement should be determined
in relation to the position of the PC. 
Place it upright next to or slightly above the PC. 
Note that if the Reserator is placed lower than 
the PC, the PVC tube’s internal air pressure 
may prevent proper initial operation.   

5. 2 Install the Supports

Install  the  enclosed  Supports  on  to  the  Tab
located on the bottom of the Reserator with
the use of Bolts. 

5. 3 Fill the Coolant

1) Take off the Reserator Cover after unscrewing

its Bolts.  

2) Fill with the provided coolant (ZM-G300,

250

㎖

) and one liter of distilled water. 

Note 1)

Fill in approximately 50% to avoid
overflow within the Reservoir, and

must refill because the water level

decreases once the coolant begins to
circulate after perfectly releasing the
air within the Reservoir. 

Note 2)

The provided coolant is a concentrate, 
and must be mixed down with distilled

water in the ratio of 1:4. 

Note 3)

Read the warning label on the coolant
before use. 

Note 4)

Keep this product and its associated
system away from children.

((O

O))

((O

O))

((XX))

((XX))

Bolt
Reservoir Cover

Reservoir

Distilled Water

G300