TNN 500A
www.zalman.co.kr www.zalmanusa.com
44
2. Installing the HDD Cooler
Parts required for assembling the HDD Cooler are:Bolts (2 types), Ground Wire, and Damper.
1) Confirm the location of the holes and place the HDD Cooler over the HDD. Using four (4) bolts (FH #6-
32X13), fasten the HDD onto the Al Bar.
2) Install on the HDD/ODD Bracket
(1) Put four (4) Dampers on the Al Bar. While doing this, use one of the Dampers to connect the round
terminal of the Ground Wire to the Al Bar. Fasten the completed assembly onto the HDD/ODD
Bracket. Then, connect the Y terminal of the Ground Wire to the HDD/ODD Bracket.
Damper
Bolt(PH #6-32X7) Bolt(FH #6-32X13)
Ground Wire
Holes
Holes
Damper
HDD/ODD Bracket
Ground Wire
Al Bar
Al Bar
Bolt(FH #6-32X13)
Ground Wire
Bolt(PH #6-32X7)