11
5.4
SETTING UP
ATTENTION: the protection N must be in vertical position towards down, if it results too
much loose, clasp the bolt places on the hinge O.
Operating procedure (see FIG. III)
1- position the cap under the bell M. This one remain connected by means of the magnet placed on it;
2- position the bottle to be capped on the support plane H, putting it to the bottle holder L;
3- pull at the same time with both hand the two levers C and P;
4- at the end of the corking release the two levers and
remove the bottle corked ;
5- repeat the operation for each bottle.
FIG. III
5.5
EVENTUAL CORKING FOR PLASTIC MUSHROOM CORKS
Position the cap in vertical position on the mouth of the bottle, pressing it slow. Centering the bottle with
the corking head M, assured that there is a correct space trough the top of the cap and corking head
(approximately 2 cm).
Then, proceed to corking, pulling at the same time the two levers C and P.
