APPEARANCE
FEATURES
● 4-channel radio transmitter (remote control),
● remote control of EXTA FREE system receivers,
● possibility of independent control of four receivers,
● wide range of operation (up to 250 m),
● battery powered,
● modern design with extra, practical chain finished with a key ring,
● possibility of simultaneous switching on/switching off any number of
EXTA FREE system receivers,
● possibility of increasing operation range by means of RTN-01 retrans-
mitter.
Optic signalling of transmitter’s operation
Push-buttons
OPERATION
After pressing the push-button the remote control sends a signal on
868,32 MHz which controls EXTA FREE receivers. Device programming
procedure (adding a transmitter to the transmitter’s memory) is described
in manual instruction of particular EXTA FREE system receivers. The
range (up to 250 m depending on a receiver) can be changed by means
of a retrasmitter or few RTN-01 retransmitters.
BATTERY CHANGE
Battery discharge status is signalled by several LED red diode
flashes during transmission time.
Remove the screws from the bottom part of the remote control.
Remove the upper cover with the silicon keyboard.
Remove the battery from the latch.
Mount a new battery.
Watch battery polarisation marked on the
latch. Wrong battery mounting may cause device damage.
Place back the top cover with the keyboard and tighten the screws.
CAUTION: While changing the battery, it is suggested to press
any of the buttons for about 5 seconds before putting it into a
latch. Next press transmission button several times to check its
operation. If the transmitter does not work properly repeat the
battery change procedure.
