VER. 007_22.08.2011
CUSTOMER COMPUTER CONFIGURATION
*5/GHIDXOWFRQ¿JXUDWLRQ
,3DGGUHVV
192.168.1.10,
0DVN
255.255.255.0,
*DWHZD\
192.168.1.1
In order to receive a connection with GRL-01 device by means of LAN interface, proper con-
¿JXUDWLRQRIFXVWRPHUQHWZRUNFDUGLVUHTXLUHG
In
CONTROL PANEL
in
NETWORK CONNECTION
open the
CHARACTERISTICS
section
of local connection.
START >> SETTING >> CONTROL PANEL >> NETWORK CONNECTION >> CHARAC-
TERISTICS
It is required to adjust in
TCP/IP
protocol characteristics:
,3DGGUHVV
address from 192.168.1.xxx, (192.168.1.10 is forbidden)
6XEQHW0DVN
255.255.255.0
*DWHZD\
192.168.1.1
&RQ¿UPDOOVHWWLQJVZLWK2.FRPPDQG0DNHFRQQHFWLRQEHWZHHQFRPSXWHUQHWZRUNFDUGDQG
GRL-01 LAN socket. To carry it out use a pair twisted cable ended with RJ-45 plug.
Check if GRL-01 device is connected with network card - LED green diode in (GRL-01 device)
/$1VRFNHWÀDVKHV
CONFIGURATION BY MEANS OF WWW
BASIC OPERATING MODES
$FFHVVWRWKHFRQ¿JXUDWLRQSDQHOLVREWDLQHGE\PHDQVRIW\SLQJDGHIDXOWDG
-
dress of GRL-01 device in a browser:
KWWSV
,WLVUHTXLUHGWRFRQ¿UPWKHFHUWL¿FDWHEHIRUHORJJLQJLQRUGHUWREHLQDVDIH66/
connection.
Next the user name and password are required.
Default:
User:
DGPLQ
Password:
DGPLQ
0DQXDO FRQWURO 212)) ±
enables receiver’s
remote switching on / switching off which is con-
nected to GRL-01 socket.
Status change is signalled in status bar and also by
means of a LED red diode.
Relay status, after power supply has been applied,
FDQEHFRQ¿JXUHGLQVHFWLRQÄ5HOD\FRQ¿JXUDWLRQ
after power supply switch on”.
21±
relay switched on,
2))±
relay switched off.
