1.
With the thigh strap facing up, hold the product with both
hands and slide it up to your knee until the top edge of
the patella opening is approximately 2 cm (0.8 inches)
above the top of your patella.
Patella
2 cm
(0.8 inches)
Thigh strap
2.
Straighten your knee and fasten hook-and-loop fasteners
A and B until your required compression level.
Hook-and-loop fastener B
Hook-and-loop fastener A
3.
Fasten the thigh strap to your required compression level.
Thigh strap
4.
Fasten Double X (cross) Straps below the knee: strap (1)
to the inner side of your knee and strap (2) to the outer
side of your knee.
Double X (cross)
Straps
(1)
(2)
Correctly fastened product
[Front view]
[Side view]
[Back view]
5.
Make sure that the product is not loose or out of place.
If you feel any discomfort, repeat the steps from the
beginning to reattach the product.
How to remove
Functional Resin Stays
(both sides)
CAUTION
1. Remove all hook-and-loop fasteners.
2. Hold the lower end of the Functional Resin Stays on both sides and
remove the knee support while pulling them downwards.
* Avoid removing the product by turning it inside out. Doing so may damage the
Functional Resin Stays.
Reporting Obligation
If you have any complaints about the product, please contact your medical retailer directly. It is only necessary to notify the manufacturer and the competent authority of the
member state in the event of any serious incidents that could lead to a significant deterioration of health or to death. Serious incidents are defined in Article 2 No. 65 of
Regulation (EU) 2017/745 (MDR).
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
“ZAMST” and “ZAMST logo” are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
How to apply
• Before attaching this product, carefully read the "Precautions for use - Be sure to read this" section. Then follow the steps provided to ensure the
product is correctly attached.
• The attachment steps below are for your right leg. Follow the same steps for your left leg.
