©Zanda Pty Ltd – Futura Integrated Privacy Door Furniture Fitting Instructions - Page 2 of 2 (Up-dated Nov 2012)
ARCHITECTURAL RANGE FIXED DUMMY FITTING INSTRUCTIONS
These handles are design to be used with through door bolts. When solid mounting these handles the Zanda 1152 -
8mm spindle must be used. When mounting the handle on one single side of the door, use the female side of the
handle set and rear the handle fix from the opposite side of the door
.
Note: It is important to ensure solid fixing is available for handle and dummy mount screws (especially on hollow
core doors)
FITTING INSTRUCTIONS
1.
Test dummy spindle on handle to ensure it fits.
2.
Establish height and position for handle of door.
3.
Drill a 32mm diameter recess on face of door to a depth of 4mm.
4.
Fit the dummy spindle by drilling and fitting three wood screws.
NOTE:
For handles with grub screws, ensure the grub screw on the lever and the groove on the spindle are aligned (in
most cases this in on the bottom.)
5.
Install the handle on the spindle ensuring that it sits square on the doors face.
6.
Mark out and drill the 6.0mm (or ¼”) holes for the through bolts and attach the handle by screwing the through
bolts up from the opposite side of the door.
7.
Tighten up the grub screw on the lever.
NOTE:
The grub screw may need a re-tighten after bedding-period.
DOUBLE DOOR DUMMY FIXING MOUNT
Refer to instructions above when fitting double doors with dummy mounts back to back.
NOTE:
Take extra care when working through step 2 of the instructions above when establishing the height
and position of the on the door, be sure to mark out both sides of the door the same to ensure the handles are
even on both sides.
NOTE:
Fit handles to door using the through bolts provided.
