6
Safety Relay MINOS SD1E
5. Disclaimer and warranty
If the above mentioned conditions for appro-
priate use are not complied with or if the
safety instructions are not followed or if any
maintenance operations are not carried out as
required, this shall lead to an exclusion of
liability and loss of warranty.
ATTENTION!
We would like to point out that it is the full
responsibility of the operator to ensure a plant
availability.
Using the SD1E, a safety emergency stop
relay according to
•
EN ISO 13849-1
•
IEC 62061
•
IEC 61508
•
EN 50156-1
•
EN 746-2
•
IEC 61511-1
is used, which will be brought into the safe
state when the safety function is requested.
This means that the connected load is
switched off as soon as a request from con-
nected sensor elements or diagnostic meas-
ures detects a dangerous state, e.g. caused
by a component fault.
Since process-related applications in particu-
lar have high demands on availability, limited
availability can also have significant conse-
quences.
It is therefore recommended to stock a sec-
ond unit to avoid long downtimes in such a
case.
These are recommendations of the manufac-
turer, the evaluation of the importance of the
plant availability is the sole responsibility of
the operator.
Summary of Contents for MINOS SD1E
