7
Safety Relay MINOS SD1E
EN
6. Features
•
Use up to PL e, Cat. 4, SILCL 3
•
Certified for operation in
furnaces and vessels according to
EN 50156-1 / EN 746-2.
•
Stop Category 0 according to EN 60204-1
•
1 two-channel safe input
•
1 safe relay contact
•
1 auxiliary output (PNP)
•
Automatic or monitored manual start
selectable at the device
•
6.8 mm width
•
Extensive monitoring via front LED‘s
7. Function
Config-Switches S1 and S2:
At the back of the device are two slide-
switches (S1 and S2) to configure the SD1E.
The following functions can be configured:
With the Config-Switch
S1
, the function of the
safety circuit at I1 / I2 can be configured.
According to your application a cross circuit
monitoring can be enabled or disabled (see
Fig. 1)
With the Config-Switch
S2
, the function of the
start input at S21 can be configured. An
automatic start or an monitored, manual start
can be set.
For this, turn the SD1E until the printed
configurationtable (see Fig. 1) is facing up
and the opening at the back of the device is
visible. Two slide switches can be seen,
which you can slide to the left or right side
depending on the desired configuration (see
Fig. 1).
Summary of Contents for MINOS SD1E
