78
FO 0030
Fig. 12
Fig. 13
When cleaning the shelf supports, take
care not to remove the lubricating
grease behind the telescopic runners.
This is meant to ensure their good
operation.
Oven door cleaning
For a better cleansing of the oven door, you
are suggested to remove it from the
appliance with the following procedure:
- open tho door completely; lift the small
levers placed on the two hinges and turn
the levers towarde the inside (Fig. 11).
- Slowly close the oven door, until it
touches the two levers,
- then push it towards the oven and remove
it by pulling it towards the outeide.
- Place the door on a horizontal level.
After cleaning, assemble the door again by
carrying out the procedure described above
backwards. When the two small levers are
placed again on the hinges, the door will
have been accurately fit.
Replacing the oven light
Disconnect the appliance from its power
supply point. Push in and unscrew the glass
cap (Fig. 12). Unscrew the light bulb and
replace it with a new heat-proof bulb (300°C)
having the following features: - Operative
tension: 230 V (50 Hz); - Power: 25 W; -
Fitting: E 14. Reconnect the appliance.
The Hinged Grill
Some models are fitted with a hinged grill
element, to enable you to clean the roof of
the oven easily.
Before proceeding ensure the
oven is cool and is isolated from
the electricity supply.
l
Undo the screws which hold the grill in
place (see Fig. 13). When doing this
operation for the first time, we
recommend using a screwdriver.
FO 0452
Fig. 11
l
Then gently pull the grill downward to
allow access to the oven roof.
l
Clean the oven roof with a suitable
cleaner and wipe dry before replacing the
hinged grill element.
l
Gently push up the grill element into
place and firmly screw into place the
holding nuts.
Ensure the grill holding nuts are
firmly in place to avoid the grill
falling down when in use.
