Climate
class
Ambient temperature
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be guaranteed
within the specified temperature range. If
you have any doubts regarding where to
install the appliance, please turn to the
vendor, to our customer service or to the
nearest Authorised Service Centre.
Electrical connection
• Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to
your domestic power supply.
• The appliance must be earthed. The power supply
cable plug is provided with a contact for this
purpose. If the domestic power supply socket is not
earthed, connect the appliance to a separate earth
in compliance with current regulations, consulting a
qualified electrician.
• The manufacturer declines all responsibility if the
above safety precautions are not observed.
• This appliance complies with the E.E.C. Directives.
Ventilation requirements
The airflow behind the appliance must be sufficient.
5 cm
min.
200 cm
2
min.
200 cm
2
Caution! Refer to the assembly
instructions for the installation.
Operation
Switching on
1. Insert the plug into the wall socket.
2. Turn the Temperature regulator clockwise to a
medium setting.
Switching off
To turn off the appliance, turn the temperature regulator
to the "O" position.
Temperature regulation
The temperature is regulated automatically.
1. Turn the Temperature regulator toward lower
settings to obtain the minimum coldness.
2. Turn the Temperature regulator toward higher
settings to obtain the maximum coldness.
A medium setting is generally the most
suitable.
However, the exact setting should be
chosen keeping in mind that the
temperature inside the appliance
depends on:
• room temperature,
• how often the door is opened,
• the quantity of food stored,
• the location of the appliance.
Caution! If the ambient temperature is
high or the appliance is fully loaded, and
the appliance is set to the lowest
temperatures, it may run continuously
causing frost to form on the rear wall. In
this case the dial must be set to a higher
temperature to allow automatic
defrosting and therefore reduced energy
consumption.
15