User mode
While the appliance is in programme selection mode:
1. Press and hold programme button until the indicator
starts to flash and the indicator
is on.
In user mode can be changed:
• The level of the water softener according to the water hardness.
• The activation or the deactivation of the acoustic signal for end of programme.
These settings will be saved until you change them again.
Reset function
Press the programme button until all programme indicators are on (Programme selection mode).
With this function you can cancel the running programme.
Adjusting the water softener
1. While the appliance is in user mode, wait until the indicator
go off and the indicator
starts to flash. The
current setting is indicated by the number of flashes of the indicator
(e.g. 5 f pause + 5 flashes =
level 5).
2. Press the programme button to change the setting. Each time you press the button, the level increases. After
level 10 you will start again from level 1.
3. Press the on/off button to confirm the setting.
The water hardness table
German degrees
(°dH)
French degrees
(°fH)
mmol/l
Clarke degrees
Water softener lev-
el
47 -50
84 - 90
8.4 - 9.0
58 - 63
10
43 - 46
76 - 83
7.6 - 8.3
53 - 57
9
37 - 42
65 - 75
6.5 - 7.5
46 - 52
8
29 - 36
51 - 64
5.1 - 6.4
36 - 45
7
23 - 28
40 - 50
4.0 - 5.0
28 - 35
6
19 - 22
33 - 39
3.3 - 3.9
23 - 27
5 1)
15 - 18
26 - 32
2.6 - 3.2
18 - 22
4
11 - 14
19 - 25
1.9 - 2.5
13 - 17
3
4 - 10
7 - 18
0.7 - 1.8
5 - 12
2
<4
<7
<0.7
< 5
1 2)
1) Factory setting
2) Do not use salt at this level.
Activating the acoustic signal for the end of programme
By default this acoustic signal is deactivated but it is possible to activate it.
1. While the appliance is in user mode, within about 5 seconds press programme button: the indicator
is on and
the indicator
starts to flash.
18
