3. To install the spray arm back, press it downwards.
External cleaning
• Clean the appliance with a moist soft cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive cleaning
pads or solvents.
Internal cleaning
• Carefully clean the appliance, including the rubber
gasket of the door, with a soft damp cloth.
• To maintain the performance of your appliance, use
a cleaning product designed specifically for
dishwashers at least once a month. Carefully follow
the instructions on the packaging of the product.
• Do not use abrasive products, abrasive cleaning
pads, sharp tools, strong chemicals, scourer or
solvents.
• Using short-duration programmes regularly can
cause grease and limescale buildup inside the
appliance. Run long-duration programmes at least
twice a month to prevent the buildup.
Removal of foreign objects
Check the filters and the sump after each use of the
dishwasher. Foreign objects (e.g. pieces of glass,
plastic, bones or toothpicks, etc) decrease the cleaning
performance and can cause damage to the drain pump.
1. Disassemble the filters system as instructed in this
chapter.
2. Remove any foreign objects by hand.
Caution! If unable to remove the
objects, contact an Authorised
Service Centre.
3. Reassemble the filters as instructed in this chapter.
Troubleshooting
Warning! Improper repair of the
appliance may pose a danger to the
safety of the user. Any repairs must be
performed by qualified personnel.
The majority of problems that can occur can be
solved without the need to contact an Authorised
Service Centre.
Refer to the below table for information on possible
problems.
With some problems, the dedicated indicator flashes
intermittently to indicate a malfunction and the alarm
code.
Problem and alarm code
Possible cause and solution
You cannot activate the appliance.
•
Make sure that the mains plug is connected to the mains
socket.
•
Make sure that there is no damaged fuse in the fuse box.
The programme does not start.
•
Make sure that the appliance door is closed.
•
The appliance recharges the resin inside the water softener.
The duration of the procedure is approximately 5 minutes.
34
