How to fill the rinse aid dispenser
M
AX
1
2
3
4
+
-
A
D
C
E
B
Caution! Only use rinse aid designed
specifically for dishwashers.
1. Press the release button (D) to open the lid (C).
2. Fill the dispenser (A) until the rinse aid reaches the
marking ''MAX''.
3. Remove the spilled rinse aid with an absorbent
cloth to prevent excessive foam formation.
4. Close the lid. Make sure that the release button
locks into position.
Fill the rinse aid dispenser when the
indicator (E) is clear.
You can turn the selector of the released
quantity (B) between position 1 (lowest
quantity) and position 4 or 6 (highest
quantity).
Daily use
1. Open the water tap.
2. Press the on/off button to activate the appliance.
Make sure that the appliance is in programme selection
mode.
• If the salt indicator is on, fill the salt container.
• Make sure that there is rinse aid in the rinse aid
dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme for the type of
load and the degree of soil.
Using the detergent
20
30
A
B
C
Caution! Only use detergent specifically
designed for dishwashers.
1. Press the release button (B) to open the lid (C).
2. Put the detergent, in powder or tablets, in the
compartment (A).
3. If the programme has a prewash phase, put a small
quantity of detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the release button
locks into position.
Setting and starting a programme
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the appliance.
Make sure that the appliance is in programme
selection mode.
3. Press the programme button repeatedly until the
indicator of the programme you want to select
starts flashing.
4. Close the appliance door to start the programme.
Opening the door while the appliance operates
Opening the door while a programme is running stops
the appliance. It may affect the energy consumption and
the programme duration. After closing the door, the
appliance continues from the point of interruption.
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by AirDry
function.
30
