ZANKER ZKC390A, Operating And Installation Manual

PPO

OSSIITTIIO

ON

N

Place the freezer horizontally on a firm surface, resting

on all four plastic feet. Use a wooden block or similar

object to compensate for any bumps/holes in the

surface.
The room should be dry and adequately ventilated.
If the room temperature exceeds 32°C, or falls below

freezing point, the freezer will not function as it should.
Do not place the freezer close to sources of heat,

radiators, chimneys, etc., and do not place the freezer in

direct sunlight.
If the freezer has been handled standing on end it should

be allowed to stand in normal position for about 12 hours

before switching it on.
Please ensure that when the appliance is installed it is

easily accessible for the engineer in the event of a

breakdown.

SSW

WIITTC

CH

HIIN

NG

G  O

ON

N

Before switching on, the freezer should be cleaned inside.

See under “Maintenance”.
Set the thermostat button in middle position. Allow the

freezer to run for several hours before placing food inside.

INSTALLATION

EELLEEC

CTTR

RIIC

CA

ALL  R

REEQ

QU

UIIR

REEM

MEEN

NTTSS

Before switching on, make sure that the voltage of your

electricity supply is the same as that indicated on the rating

plate, located inside the lid.

WARNING: 

This appliance must be earthed.

33