1. Press and hold the start/cancel button. Turn the
programme knob clockwise until the first washing
programme on the programme knob agrees with
the on/off indicator light.
2. Release the start/cancel button when the on/off in-
dicator light and the start/cancel indicator light start
to flash.
– At the same time, the end indicator light flashes
to show the level of the water softener.
Example:
5 flashes, pause, 5 flashes, pause, etc... = level
5
3. Press the start/cancel button one time to increase
the water softener level by one step.
The end indicator light shows the new level.
4. Turn the programme knob to the off position to save
the operation.
Use of dishwasher salt
Caution!
Only use dishwashers salt. Types of
salt that are not applicable for dishwashers cause
damage to the water softener.
1
2
3
Fill the salt container with
1 litre of water (only the
first operation).
4
5
6
It is normal that water overflows from the salt
container when you fill it with salt.
Make sure that there is no grain of salt outer of
the salt compartment. Salt which stays on the
tank for a while drills the tank. It is recommended to
start a washing programme immediately after you fill
the salt container. This prevents of corrosion because
of spilled salt.
Important!
Fill the salt container from time to time.
The salt cap has a refill indicator window in the center.
A green float is easy to see when there is a salt inside
the container. It almost goes out of view when the salt
is gone.
21
