Setting and starting a washing programme
Do these steps to set and start a washing programme:
1. Close the door.
2. Turn the programme knob to set the washing pro-
gramme. Refer to the chapter 'Washing pro-
grammes'.
– The on/off indicator light comes on.
– The phase indicator light for the washing pro-
gramme starts to flash.
3. Press the start/cancel button.
– The washing programme starts automatically.
– The start/cancel indicator light comes on.
– When the programme starts, only the phase in
progress indicator light stays on.
When the washing programme operates, you
cannot change the programme. Cancel the wash-
ing programme.
Warning!
Only interrupt or cancel a washing
programme if necessary.
Caution!
Open the door carefully. Hot steam can
come free.
Cancelling a washing programme
• Press and hold the start/cancel button for approxi-
mately 5 seconds.
– The start/cancel indicator light goes off.
– The phase indicator lights starts to flash.
The washing programme is cancelled.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme.
Fill the detergent dispenser with detergent before
you set a new washing programme.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of inter-
ruption.
End of the washing programme
Switch off the appliance in these conditions:
• The appliance stops automatically.
• The end indicator light comes on.
For better drying results, keep the door ajar for some
minutes before you remove the dishes.
Let the dishes cool down before you remove them from
the appliance. Hot dishes are easily damaged.
Removing the load
• First remove items from the lower basket, then from
the upper basket.
• There can be water on the sides and door of the
appliance. Stainless steel becomes cool more quick-
ly than the dishes.
Care and cleaning
Warning!
Switch the appliance off before you
clean the filters.
Cleaning the filters
Important!
Do not use the appliance without the filters.
Make sure that the installation of the filters is correct.
Incorrect installation will cause unsatisfactory washing
results and damage to the appliance.
1
2
Fully clean the filters A, B
and C below running wa-
ter.
25
