USE
27
Synthesis
06/40V GAS
6. USE
During cooking or at the end of cooking some of the oven's surfaces reach
dangerous temperatures. The
symbol warns of this danger. Never touch these
surfaces and only use the proper handle.
6.1 PREPARATION FOR USE AND BEFORE TURNING
If the unit has just been installed or if it has not been used for several days before using it to
work you need to clean it completely food as described in Chapter cleaning, to eliminate
manufacturing waste, accumulations of dust or other substances that may contaminate food.
6.1.1 Ignition Control Panel
Press the on / off (Fig.1), part of the fan.After 20 seconds the
message appears on the display "Flames" and activates the
audible signal.
6.1.2 Settings and start cooking
Select the desired cooking time by pressing the push-button
,
then adjust it as required by pressing the push-buttons
and
.
Now press the push-button
and select the desired temperature
by means of the buttons
and
, then confirm.
Open the gas cock and adjust the burner switch
in the ON
position. (Fig.5) .
If at the end of the 40/50 seconds the writing
“FLAME” (FIAMMA)
appears on the display, check that the gas pipe is connected
properly and that the gas cock is open. Anyway, it may happen
that a failure occurs during the first starting trial, due to the
presence of air in the gas pipes.
Wait 5 minutes and press again on reset button (Fig. 5) to activate
the burner.
1
2
3
4
5
