11
ENGLISH
Clean it with a brush and rinse it under the shower if
necessary.
Also clean the outside, removing all fluff.
Clean the rubber seal round the condenser cabinet
and in the inner part of the small door with a damp
cloth.
Important!
Do not use pointed objects or utensils to
clean the spaces between the plates, as this could
damage the condenser and make it permeable.
Re-fit the condenser, turn the red stops upwards
and close the door.
Do not use this appliance if the condenser
has not been fitted.
Emptying the water reservoir
Water extracted from the laundry condenses inside
the machine and is collected in a reservoir.
The reservoir must be emptied after each drying
cycle to ensure efficient operation when the
machine is next used.
If this is not done a safety device trips: pilot light
on the control panel comes on and the programme
stops, leaving the laundry damp (see page 6).
The reservoir can be emptied even in the middle of
a programme.
Proceed as follows:
•
Pull out the reservoir
•
Turn it upside down and let water flow down
•
Re-fit the reservoir
P11
57
P11
5
6
P063
9
The reservoir must be re-inserted correctly.
The machine can remain unactive up to 2 minutes
before starting the programme and during this
period the water container light
remains alight.
Handy tip
: The condensed water may be used in a
steam iron or to top up a battery, etc. In this case it
must be filtered (e.g. through a coffee filter).
Cleaning the air intake grille
Using a vacuum cleaner remove the fluff from the air
intake grille at the back of the appliance.
P116
2
125992363.qxp 2005-04-06 14:18 Page 11
