Zanussi Electrolux ZEBF 249 W, Instruction Booklet

7

Normal Operating Sounds 

The advanced design of today’s frost free appliances mean you hear unfamilar noises during everyday
operation. The diagram below describes some of the noises you may hear. These are quite normal and mean
your appliance is operating correctly

The thermostat control will

click when starting or

stopping the compressor.

Defrost water drips into the

drain pan during the defrost

cycle.

The automatic defrost timer

sounds like an electric clock

and clicks in and out of the

defrost cycle.

The fan circulates cold air to

cool the refrigerator and the

freezer compartment and

sounds like air blowing or a

whirring sound.

The flow of refrigerant

through the freezer cooling

coil makes a gurgling noise.

Water dropping on the defrost

heater causes a hissing or

popping sound during the

defrost cycle.

The compressor will make a

humming or pulsating sound

while operating.

14

INSTALLATION

Positioning

This appliance should only be installed at a location
where the ambient temperature corresponds to the
climate classification indicated on the rating plate,
which is located at the left on the inside of the
appliance.

The following table shows which ambient temperature
is correct for each climate classification:

SN    +10°C  to  + 32°C

N      +16°C  to   + 32°C

ST    +18°C  to   + 38°C

T       +18°C  to  + 43°C

It should be located in a dry atmosphere, out of direct
sunlight and away from extreme temperature e.g. not
next to a boiler or radiator, or in a very cold room e.g.
an outhouse, where the temperatures may fall below
10°C (50°F). If these temperatures are exceeded i.e.
colder or warmer, then the appliance may not operate
correctly.

You should also ensure that air can circulate freely
around the back and the top of the cabinet. There
must also be at least 100 mm (4”) distance between
the top of the cabinet and any overhanging kitchen
furniture (A). Ideally, the appliance should not be
positioned beneath overhanging furniture (B).

There should also be a gap of 25 mm either side of
the appliance. Do not obstruct the space underneath.

Rear spacers

The plastic bag containing all relevant documentation
also contains two spacers to be fitted into special
holes in the back of the appliance.

Fit the spacers into the holes, taking care to ensure
that the arrow (A) is positioned as shown in the
diagram. Then turn them through 45° (arrow (A)
vertical) until they lock into place.

DO NOT install in places with restricted ventilation.

Adjust the level of the appliance by screwing out the
adjustable foot, or feet, at the bottom of the cabinet
using your fingers or a tool (see figure).

D200

NP00

100 mm

10 mm

10 mm

A

B

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE
THAT HAS A LOCK OR CATCH ON THE DOOR,
YOU MUST ENSURE THAT IT IS MADE
UNUSABLE TO PREVENT YOUNG CHILDREN
BEING TRAPPED INSIDE.

PR60

A

45°

Important

It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.

Depending upon the position which you choose for
your appliance, you may wish to reverse the way in
which the door opens. To do this, refer to instructions
on “Door reversal directions” paragraph.