Zanussi Electrolux ZEF 100 W, Instruction Booklet

Door Reversal

13

Before carrying out the operations described below,
pull out the mains plug from the wall socket.
To carry out this reversal go through the following
steps:

1. Gently lay the appliance on its back with the top

held away from the floor by 5-8 cm (2-3 inches) of
packing.

2. Remove the bottom door hinge (5).

3. Remove the door (4) by opening it and pulling it

gently downwards to remove it from the top hinge
pin (2).

4. Unscrew the top hinge pin (2) from the top hinge

(1) and replace it in the opposite hole on the left
hand side.

5. Unscrew the foot at the base (6) of the appliance

and refit it on the opposite side.

6. Refit the door and the bottom hinge (5) to the left

hand side.

When positioning the bottom hinge blade on the
reverse side, the securing screws will require a
degree of exersion when fitting.
It is therefore advisable to lubricate the screw
tips before starting this operation.

Important

After completion of the door reversal
operation, verify that the door gasket is sealing
onto the cabinet.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting
of the gasket or accelerate this process by
heating up the part involved with a normal
hairdryer on a low setting.